Elma Instruments Elma easy-iso insulation adapter

When you make an insulation test on curcuits with elektronical equipment included, you should connect all phases and neutral together, during the measurement. In this way you are shure about, that there will be no potential between the leads, and therefore you will avoid accidents with electronical equipment and sensitive equipment. With the new Easy-ISO it is even more easy to make above written connections, and then make the measurement. Easy-ISO includes four Ø6,6 mm magnetical probes and a 4-pole test lead, which is connected together as one test lead. The magnetical probes are holding the wire fixed automatically on the measuring point, not using any other helping tools. An insulation test is made on an installation with no voltage present. Disconnect eg. on the RCD and connect the Easy-ISO on the downstream on a 4-pole curcuit breaker. If all the groups on the curcuit breaker is on, then you normally is able to measure the hole installation at once. Using this method all the installation is shortedit is important to disconnect Easy-ISO, before turning on the voltage. Elma Easy-ISO leveres i lille taske og opfylder IEC 61010-1 KAT III 600V.